help setting t-slot parameters

[Gary Jordan]

I cant get the depth of cut right on the T-Slot can someone give me a hand.

Thanks

Gary Jordan

[K2csq7]

Love to give you a hand, but we can't until you give us more info? Did you read the "new users please read"?

 

Welcome to the forum

[jhjr]

Lil more info would be nice. Make sure your depth is set to the bottom of the slot in parameters not the top & use depth cuts if needed. Chain can be at any depth but your depth parameters must be set right. Don't worry, all new users do something like that I know I did on my first post. I think they should make new users read the guidelines before you can post like you have to do when downloading somethings when signing the agreement. I know most don't read those things but it could help cause there aren't that many guidelines. Even make you look at it two times so you really read it.

 

Welcome to the forum, there are a lot of good programmers in here that are willing to help. I have learned many things that I've never thought to ask along with my questions. Don't be afraid to search for things, there's alot of info there also.

[Gary Jordan]

I have my parameters set right. the starting point and the exiting point of my tool is in the center of my part and i need it on the edge. i have tried to move the starting point and it is not doing any thing.

 

Thanks

Gary jordan

[SCOTT.R]

If its a closed contour make sure you dont have the enter/exit at midpoint checked in your lead in/out page. That has got me a few times when i tried to move my start points..

[Gary Jordan]

Ok i will try that thanks for the help

Gary Jordan