Dynamic Mill Z start point

[Newbeeee™]

Hi All,

Ref dynamic mill.

 

Going say 2" deep, with 1" depth of cuts (ie 1x pass at Z-1, 2nd pass at Z-2).

1st pass works well, Z starts spiralling at Z.1 down to Z-1 and runs.

2nd pass starts spiralling at Z.1, (cutting lots of air down to -1) and then down to Z-2 and runs fine.

So question of the day: is there any buttons I'm missing to have the 2nd pass start at say Z-.9???

 

Cheers

[K2csq7]

???? I can't get it right... a workaround would be skip depth cuts, first op depth of -1. then copy the op & change the top of stock & depth.

 

Hopefully someone can show us the right way...

[Goldorak]

it's a known bug for dynamic mill

 

hope they fix that in X5

 

for the moment i copy my operation and change the top of stock to avoid the air cutting

[Newbeeee™]

Thanks for the feedback.

Yep, fingers crossed for X5!