Setup sheet output???

[mmetzinger]

Good morning.

 

I am outputting a setup sheet to give to the machine operator. I saw that one of the descriptions I put on a tool needed more clarification, so I went back into the tool, changed my description (I put this in the "comment" line on the parameters page inside the tool), tried to output a new setup sheet, and it WILL NOT recognize the new description I put in the comment line!! A bit frustrating to say the least.

 

Hoping for an easy fix. Any help would be greatly appreciated. Thanks in advance.

 

Matt Metzinger

[McRae]

Regen the operation in the Ops Mgr and then run Setup Sheet again. Ying @ InHouse gave me this solution for a custom tool form. Same principle.

[mmetzinger]

I will try that. I actually thought I did that, but I will try it again. Thanks.