chamfer problem

[Accu-Molder]

I'm trying to get a chamfer on the inside of my solid .0009back and .0516 deep and can't get anything to work. I've posted the file on the ftp in mc9 folder name is chamfer problem. thanks for any help Justin

[cadcam]

So you want a chamfer at .0009?

And you want this .051 deep. that seem strange.

But I am looking at it.

 

Ok now i see just how small the part is.

 

[ 02-21-2003, 11:03 AM: Message edited by: cadcam ]

[Dan Bedore]

Justin I tryed to upload the file with no success. i will email it

[cadcam]

OK its done and up on the FTP.

[Accu-Molder]

Thanks Jay did you get this with 2dist. chamfer or a sweep method just wondering I could get outside to chamfer but not inside at these dist.

[Accu-Molder]

When I try this with 2dist. I get a blend error every time what am I doing wrong

[Dan Bedore]

Justin look at the solid manager- parameters and you will be able to see how the chamfer was made

[Dan Bedore]

Justin did my chamfer turn out the same as cadcams? if it did I used 2dist edge and propagate along tangencies.

[Accu-Molder]

Yes it looks great but I can't get it to work on my computer I used 2dit. and propagate along tangencies and get a blend error saying it completely overlaps edge I try one edge and tryed picking them all and still same error I'm confused on what I could be doing wrong or differentely then what you guys did.

[Dan Bedore]

I put n for from back,face,and verify.y for edge. i choose the edge and make sure the right edge is lit up by choosing other untill i am sure. then i move to the next section and do the same ect untill i get all the way around do them in order and none twice.then done dist1 .0009 dist2 .0516 then check propagate then ok

[Accu-Molder]

Yes, I had wrong adjacent face selected thanks for the help Dan.