Cincinnati Milicron

[Lucky 7]

I have a little project to do. I am looking for a good starting post for a Cincinnati Milicron Sabre 2000 with a 850 Acromatic controller. I only have a little experience at editing a post. Does any one know of a good starter post that will run on this controller with minimal problems?

 

I am not asking for a post!!!! so please go lightly on me.

 

I just didn't know if the mpmaster was a good starter post or if there was another that I should start with?

 

Thanks

[Guest CNC Apps Guy 1]

Mpcin850 is probably your best bet to start with.

 

HTH

[Lucky 7]

Thanks James

I'll give it a try.