OptiRough Steep/Shallow

[jrauch]

I really like the new Optirough path, but the issue I am having is when I try to use the steep/shallow to force path to start above the geo "because stock size" it will generate a path but it stops at the top of the part in Mastercam and wont go any deeper. If I disable steep/shallow it starts just above the model and creates a great looking path roughing the entire part. Anyone else seeing this?

[neurosis]

I really like the new Optirough path, but the issue I am having is when I try to use the steep/shallow to force path to start above the geo "because stock size" it will generate a path but it stops at the top of the part in Mastercam and wont go any deeper. If I disable steep/shallow it starts just above the model and creates a great looking path roughing the entire part. Anyone else seeing this?

 

 

I have been using steep/shallow without any problems at all. What do you have your minimum and maximum depths set to?

[Goldorak]

you have to set the step up to get mcam to go to the bottom of the pocket

 

i get the same problem yesterday and this is what i did to solve the problem