Dynamic Mill entry options

[DavidSV]

I want to drill an entry spot with an inserted drill and then have the endmill plunge into my drilled hole and start dynamic milling from there. Is there any way to do that? I have tried all sorts of entry methods and can't seem to get it to work that way. Any suggestions?

 

Thanks

David

[Tony35]

x2 this is the best to save your corner, set entry angle to 90° and radius at 0, select "enter on helix point" . it will plunge strait in the hole but Friday i ordered a EFPI end mill from iscar, i can't wait to try it, it's like a Christmas gift :)for speed and feed you can refer to this: dynamic database my settings for 304 are pretty good and they are 500% tested ;)

 

here is the link to the thread

LINKY

 

hope this helps ya out

[Goldorak]

 

it also work with optirough

[DavidSV]

Actually, I am milling a slot through a part. Peel kill was kind of rough on entry, so I was trying a dynamic tool path instead. Then I saw the peelmill help thread and saw how they did the slot with the dynamic tool path.