G54.2?

[Matthew Hajicek - Singularity]

I'm trying to use dynamic work fixture offset on a Fanuc 18i control, and I think I have all the parameters set but I'm not sure how to use it in the code. It seems I can't have it in the same line as the G54-G59. Does anyone have some sample code using it? I googled and found a bunch of people asking about it but no answers.

 

Thanks!

[MIL-TFP-41]

M22 (UNCLAMP)
G54.2 P1
G0 G17 G90 G54 B90. X-17.0139 Y5.4693 S600 M03
M21 (CLAMP)
G43 H#518 Z12.

blah blah blah 

G0 Z12.
M05
G0 G90 G49 G53 Z0.
G54.2 P0
M01

 

One thing you need to make 100% sure of...When you make a move with your rotary axis, make sure you have you X, Y & Z called out along with your rotational axis (or axis's in case of a 5 axis). The above example I don't have a Z because the rotation is called out with it retracted. However, during a full 4th or 5th axis move, you need to have all axis's called out on the same line.

[Matthew Hajicek - Singularity]

Thanks a bunch, I'll see if it works here.