error posting

[TREV]

hello all,

i got an error while posting my toolpaths today. the error was "error writing to buffer file,postblock label pwrtt" i have never seen this before. other ops in same file posted fine,after i re opened the file i went off without a hitch. what gives any replies are appreciated thanks in advance

trevor btw mc v8.1 level 3

[Christian Raebild]

That is a strange error to get. What does your pwrtt postblock contain for code? Could you be running into problems with available harddisk space in the partition where your Mastercam temp directory is?

[TREV]

thanks for the reply christian,

i did track down the problem.

i had aquired an exxess amount of files in my re-gen folder inside of my mc8/mill folder. i have my config set up to delete all at end of session , but i had been working on some huge files this morning and inadvertantly had a whopping 548meg of re-gen files.

 

anyhow problem solved,

thanks for the reply.

trevor