X+ problem

[abc1234]

HI , I,m trying to use the "angle" in the x+ set up sheet. It dosen't seem to work. It only posted an angle on 4 of the 20 operations and the angles were wrong. It posted 90 deg. and the angles were 0.0 and 180.0 deg. Were trying to eliminate fat fingering numbers in to cut down on mistakes.I was

hoping the "angle" button would post the tool plane angles that we create.

 

problem # 2 - I want to use the "TL_RAd" tool radius but it only puts 2 place decimal, so if my radius is .015 it puts out .02. Is there a way to

make it 3 places?.

 

Thanks

[Elmer Fudd]

#2 Decimal places can be set at Control panel---> regional and language options--->additional settings- No. of digits after decimal. (set to 3)

[abc1234]

#2 Decimal places can be set at Control panel---> regional and language options--->additional settings- No. of digits after decimal. (set to 3)

 

 

 

Thanks Dan , that took care of that problem, now I just need to find away to get my tool plane angles to output.

[Elmer Fudd]

Your welcome.