rotary brake lock

[phil darcy]

I searched but no luck

 

Need to change the number of code that locks and unlocks brabe on 4/5 axis table

using the haas 5axis post supplied with Mastercam.

 

Thanks

[Guest]

look for this in the post

 

# --------------------------------------------------------------------------
# Primary axis lock/unlock
spunlock : "M13"     #Unlock Rotary Table
splock   : "M12"     #Lock Rotary Table    
s_plock  : ""        #Target string

fstrsel spunlock p_lock s_plock 2 -1
# --------------------------------------------------------------------------
# Secondary axis lock/unlock
ssunlock : "M11"     #Unlock Rotary Table
sslock   : "M10"     #Lock Rotary Table    
s_slock  : ""        #Target string

fstrsel ssunlock s_lock s_slock 2 -1
# --------------------------------------------------------------------------

[phil darcy]

look for this in the post

 

# --------------------------------------------------------------------------
# Primary axis lock/unlock
spunlock : "M13"     #Unlock Rotary Table
splock   : "M12"     #Lock Rotary Table    
s_plock  : ""        #Target string

fstrsel spunlock p_lock s_plock 2 -1
# --------------------------------------------------------------------------
# Secondary axis lock/unlock
ssunlock : "M11"     #Unlock Rotary Table
sslock   : "M10"     #Lock Rotary Table    
s_slock  : ""        #Target string

fstrsel ssunlock s_lock s_slock 2 -1
# --------------------------------------------------------------------------

Thanks I changed the #'s and it looks good