Hi, thanks in advance, I need to know what type turrent an Okuma lb-15 has and if anyone has the specs on tool attachment, turrent max swing with what height tools, etc. Phil

Hi, thanks in advance, I need to know what type turrent an Okuma lb-15 has and if anyone has the specs on tool attachment, turrent max swing with what height tools, etc. Phil

No Jay they are not geo and they stay on all level. I can't figure out what I before,I had recorded the driver # before reformating and the # was for 64bit xp and I have 32bit?

I had to reformate my m90 drive and lost my video driver for fx-3500m card. I have tried a handful from dell and solidworks sites. Mastercam is what causing problems with back plot. It leaves all the back plot moves and they stay,through restart,repaint,ram saver,etc. My hope is someone has a driver # thats works for them. Thanks,

Thanks I changed the #'s and it looks good

I searched but no luck Need to change the number of code that locks and unlocks brabe on 4/5 axis table using the haas 5axis post supplied with Mastercam. Thanks

thanks that worked

I am using the haas 5axes post and need to have a C instead of a B output,the numbers are correct just the letter is wrong. Hope there is a way to do this. Thanks,

no not anymore thats what gone missing.

seem to have lost the box that let you input xlength and y length with rec and lines. tryed turning all tool bar not it. thanks for your help

Anybody know where to buy steel vdi50 plugs in the US, Somebody that stocks them. Thanks

Anybody know of a good source for cad files of std lathe tools Thanks

anybody know if this control on a fadal with drive 5axes Thanks

Anybody know a way to get red of tool planes and views left over when you go a save some from a file with loads of tp and views? Thanks in advance

Would anybody share a small amout of code that drives a touch probe in a fadal I am trying to do this but can't get any 232 output. In manual it seem simple. Any help would be great,thanks