Machine Simulation with Transforms

[Guyinthedesert]

I'm trying now to run Machine Simulation on a five axis program for an impeller. The program cuts one blade, than we use toolpath transform to cut the remaining blades.

 

Simulation just skipps over the transform operation. Is there any way to make it run?

 

I can choose the copy option in the transform, and it does create a toolpath that Sim will run all the way around, but, for obvious reasons this is not what I want to do.

[Tony35]

transform is not supported in machine sim yet

[CJep]

if you're using the advanced type multiaxis toolpath there is a toolpath transform utility on the roughing page.