okuma post

[jwpainter]

Does anyone have or know where I can get a V8 post for an Okuma with the OSP3000 control that has the capability to write the code for the canned cycles that the machine is capable of?

[Rekd™]

 

'Rekd teh INCOMING!!!

[Philcott]

JW,

 

Have a read of the faq.

 

Phil

[Allan]

There are several post arround that will support the LAP3 cycles of the OSP controls. I've personally never seen a OSP3000. The OSP5000 and OSP7000 seem to be most popular. Your reseller should be the first place to start looking for the post or to get yours working the way you would like.

 

How about updating to V9.1 on the condition that a post for the OSP3000 with canned cycles will be provided?

 

HTH

[Mick]

I learnt to programme on a Okuma LS-N with an OSP2200L control, and then progressed to a LS-N with an OSP3000L. I really liked that control, and I did a custom post for it that supported LAP cycles, including the G86/G33 threading cycles.

I'm sure I have it archived somewhere around here.

The old MPLOSP supposedly worked, but from memory the format wasn't correct. I remember spending a bucketload of time on it ironing it out. Ahh...the memories of starting to learn about posts