change at point

[Elad]

Hi,

 

I have a problem and i have no idea why :

 

i have a simple rectangle (100mmx100mm) with R3. in the corners.

 

i want to change the feed when the tool is going to the radius so i used change at point (right click on the chain).

after clicking on "change at point" i clicked on the point where the radius starts, and changed the feed to F50, and where the radius ends i changed back to F400.

 

It worked great, but if i try to do the same to the next radius, then after he finish the first radius it goes to the next one still in F50. and not in F400 like i need.

 

Hope you understand me.if you don't i'll try to do a little drawing and to upload it to cadcam's ftp.

 

Thanks,

[Rekd™]

Check if you have modal set or unset on both changes.

 

'Rekd teh If I had coffee, this would be more interesting..

[robk]

In Operation Manager right click your NCI Icon for the operation you wish to edit. This will open up your tool editor. Select your pass and the point you wish to edit. Hit the edit button and Edit Point. Change your feed rate and select section... Repeat for every corner. I hope this helped..