Haas ec400 simulation

[Shawn Wentzel- Wenteq Inc]

We just purchased a Haas ec400 horizontal mill. Is anyone using machine simulation with this machine? If so, are you using a standard included model or a custom made one?

[Mr. Wizzard]

We have one in our production shop, the Pallet Pool as well. I'm sure there's one in the MachSim folder. I attended the Multiaxis training at CNC Software a while ago and we had it set up on my laptop while i was there and it worked pretty sweet. I haven't used since then, however. I work in the prototype department and haven't needed to use it since. Maybe contact your reseller and have him run you through it.

[Mr. Wizzard]

It should look like this.

It's labeled as "Horiz4Front" in the drop down on the MachSim Startup Settings box.