Create arcs on multiple points

[Candyman]

Hi All,

is it possible in x3 to create an arc of a specific dia but on multiple points at once instead of one at a time .

thnaks

[uncle_dolan]

Hi All,

is it possible in x3 to create an arc of a specific dia but on multiple points at once instead of one at a time .

thnaks

Hi Paul,

 

I'm not sure about X3 but in X5 there is a function called Xform Template. You can create one arc, and then select multiple points to translate it to using the Xform Template. From memory it is not in the Xform menu, but if you go into settings and customise and scroll down to the Xform category you should be able to pull it from there and stick an icon on your toolbar. May not be the correct use of the function but i use it for this all the time and it is extremely helpful!

 

HTH Brendan

[Roger Martin from CNC Software]

There is the Pts2Arcs CHook, that's available for X4 on...

 

See Add-Ons (lower-right) on the Support-Download page

[Candyman]

Xform template worked a treat..

I didnt even know it was there..

Thanks again.

[uncle_dolan]

Xform template worked a treat..

I didnt even know it was there..

Thanks again.

No Problems, Glad I could help