contour cutting

[thereclinerman]

using version x5 router level one. i need to contour cut a five inch circle with a .5 cutter. i cant just contour cut the inside of the circle as the vaccum system sucks the plug up. i need to plunge the bit to depth and then step over .25 until the entire circle is cut out as dust. no complex cutting patters or entry is needed as i am cutting plywood. thanks for any help

[Manuel0822]

How abou pocket cutting,? On the rough parameters tab use spiral and add a finish pass to cut the id to size.

 

HTH

[gcode]

circle mill with spiral entry is about as simple as it gets