Verify stock

[Dtm]

I'm having a problem with the verify options reverting to file for stock options. If I go into the configuration and change stock shape to cylinder and choose stock setup they are not sticking I even save as my configuration, but when I close the file and reopen it reverts back to file. This is wasting all kinds of time because it take like five minutes to load the stl file. What is strange is when I save the configuration file and select the one I want to overight it gives me no warning about replacing the file.

[NOTW Programmer]

Have you tried changing it to Box ? How about deleting the config files and letting MCAM generate a new one.

[Dtm]

Have you tried changing it to Box ? How about deleting the config files and letting MCAM generate a new one.

 

Tried both.

[John Morris]

All I can say is you are not alone. I also see Verify Stock settings not sticking or reverting for no reason that I can determine. The one I see most often is when I define a cylinder off center, the center on axis box needs to be un-checked again half the time.

[NOTW Programmer]

I dont have that problem, why dont you uninstall and reinstall the software. I would clean the registry free of anything that said Mastercam and delete the Mastecam folder. Be careful if you want to deal with the registry as this can brick your system if you delete the wrong thing.