LOC automatically at tooltable output?

[PcRobotic]

Hi,

I've been working on the LOC but I got no luck. Can anybody guide me how to output LOC on the tooltable list? It should look like this. The please look at the red and bold LOC words below.

 

%

O0001 (NOVELLUS 258147-15-00 REV.NC)

(Operation # 5 Of 20)

(Customer Name: Novellus)

(Approved By: Steven Luong)

(Machine Name: Haas)

(AUG.30.2012**At-3:51 PM)

 

(****** Setup Instructions - SI ******)

(SETUP MAN MUST FOLLOW THESE PROCEDURES:)

(1. SQUARE PARTS PRIOR RUNNING FIRST ARTICAL)

(2. CHECK FIRST ARTICAL WITH Q.C)

(3. WHILE RUNNING SECOND PART AFTER QC APPROVED.)

(GO TO BUILDING 2 GET MORE RAW MATERIAL)

(3. ASK MARK TO GET CERTIFIED FROM THIS MACHINE.)

(XY0 = BACK LEFT, Z0 = TOP OF PART. PART MUST BE SQUARED BEFORE CUT)

 

(******** Tool List Info - TL ********)

(T1 - 3" FACE MILL - H1 - D1 - D3.0000" - LOC =Z -.0001)

(T2 - 1/2 FLAT ENDMILL - H2 - D2 - D0.5000" - LOC =Z -.7520)

(T3 - 1/4 SPOTDRILL - H3 - D3 - D0.2500" - LOC =Z -.3526)

(T4 - 7/32 DRILL - H4 - D4 - D0.2188" - LOC =Z -.1523)

(T5 - 1/4-20 TAPRH - H5 - D5 - D0.2500" - LOC =Z -.981)

(T6 - 2 INCH DRILL - H6 - D6 - D2.0000" - LOC =Z -1.856)

 

(******* Work Offset List - WOL *******)

G90

G10 L2 P1 X0. Y0. Z-27.965

G10 L2 P2 X20. Y0. Z-27.965

G10 L2 P3 X40. Y0. Z-27.965

G10 L2 P4 X60. Y0. Z-27.965

N1 (3" FACE MILL)

G0 G17 G40 G49 G53 G80 G90 Z0

T1 M6(SKIM CUT)

M8(LOC = Z-.0001)