Mcam7

[johan1johan1]

hello all

we are using Mcam 7 for some time now

and almost everthing is working good for us

we like the diffrents in 5-axis toolpath but

we have something we don't like

if we have toolpaths highlighted and turn the part

it will go away and come back as soon we stop to turn the part

do someone now if we could turn this feature off?

if we are using Mcam 6 it will show all time then we turn the part

[Newbeeee™]

Have a look on search as I think this has been mentioned before and it is just the way that the new verify works.

[Dan@home]

I have noticed if you slow the verify down it doesn't disappear when you move it. Maybe a graphic card issue.

[Jayson Kramer]

Really you guys get this in Verify from his posting. or is talking about if he has highlighted paths in the ops manager and shows the paths then he rotates they go away,

Or in Backblot when paths are shown in trace mode and he rotates they go away. I can see all theses from this post.

 

So johan1johan1 welcome aboard , can you tell us is it one of the following I satated or something else.

 

thanks

[johan1johan1]

hello

this is when I have them highlighted in ops manager and try to rotate the part

then I stop I will see them again

thanks for helping