tool number bug

[Rocketmachinist]

In x7 i go in and change my tool number after it had already calculated the path once. And even though it shows my tool being the correct number when I post it comes out with the previous number. The only way I have seen to fix this is to force regenerate the tool path and then it posts correctly. Has anyone else had this problem?

[Pilot Plant Supervisor]

I was hoping things like this would be fixed. I am still using X6, but when I change a tool #, it dirties the operation and I have to re-gen. The extra hour or two to re-gen everything is just ridiculous.

[Alien]

In x7 i go in and change my tool number after it had already calculated the path once. And even though it shows my tool being the correct number when I post it comes out with the previous number. The only way I have seen to fix this is to force regenerate the tool path and then it posts correctly. Has anyone else had this problem?

Hi,

Yes, I was same problem some times. And sometimes the tool number appear correct after renumbering but diameter offset and length offset stay from old number. Must be careful.

Sincerely,

Michael.

[odessa]

I had the same problem. Just put head # as a tool #