Arc Filter - Create arcs in XY

[drafting3]

Z2go

I_GOT_A_FEVER_AND_THE_ONLY_PRESCRIPTION_IS_MORE_G03_MOVES.Z2G

[drafting3]

Just wanted to mention that the post I am using was originally from version 8 or 9, i think. I found old disks laying around that had the post on it. I'm sure it needs updated.

 

 

 

I also read that you can compensate for slower processors by programming in the unit of measure that the machine's ball screws are set to.

 

The machine we use has metric ball screws, so if this programming tip is correct, I need to be sending metric G-code to the machine. I'm going to try some highspeed toolpaths in metric.

 

(i understand the theory behind this one, but i doubt it's going to help. I'm betting that conversion of units is not something that gets handled by the main processor.)

[Glenn Bouman]

I had a look at your control def and having all error check options checked is what is causing the arcs to be linearized.

 

Use this control and reload the machine def and it should be fine.

MPSNK3.zip

[drafting3]

Thank you!

 

That's perfect!