docking toolbars

[faden]

i am haveing a problem with getting my toolbars to stay docked where i want them the only one that stays put is the comand manager this started today in the past i had no problem with it keeping the toolbars where i wanted them i am useing two monitors i use a 22" monitor for doing my work on and a 17" monior to hold all my tool bars

[Pilot Plant Supervisor]

Did you save the tool bar?

[Justin Beebe at Folsom Tool]

I had this same problem before. I think the issue is that you have two different size monitors. If you set up your tool bar states on one size monitor and then open mastercam on a second monitor that is a different size the tool bars won't stay docked. My solution was to get two monitors that were the same size. Ditch the 17" and get another 22"

[faden]

it seems kind of strange that they stayed docked before useing two different size monitors it seems to have stared shortly after i updated to sp2