X7 2D Contour Toolpath wont post

[DavidB]

I'm doing a 2D contour with comp OFF with a depth of -0.1 stock set at 0 and the toolpath wont post?

 

I get a warning "Invalid tool motion detected within depth cuts. Operation require regen."

 

I've checked and everything inb the parameters is fine. I don't have depth cuts in the toolpath.

 

Cheers Dave

[Bryan Johnson]

If you click through the warning, I expect it to post code that is good.

 

I think this is caused by using window chain, and has been resolved with most current update.

 

[brandon b]

Delete the operation and check that your wcs and gview are correct . You may even have accidentally put plus .1 in your depth field

[DavidB]

Yes I clicked through the warning and the posted code looked good to me. So I ran the toolpath and all good.

 

And yes I selected the geometry by window as I normally do for engraving.

 

Cheers Dave

[slyym]

I got that as well for engraving toolpaths. Ignored it and the code was fine. Havent had any issues with Sp2.

[rogkick]

Same as above...posts ok regardless!