OT / Agie BTR

[LNDCAD]

I am working on an AGIE DEM315 WEDM with a CNC100 control. The unit was purchased used and has a Behind the Tape Reader installed. I was told it is a Macauto (McAuto???), but does not have any manual with it for cable pinouts, protocol, etc. Does anyone have any experience with these units, or any information on possible vendors? I searched the web, with no return hits. I am considering pulling it out, and replacing with a Techstar Link (probably cheaper than spending a lot of hours trying to debug a unit without a manual). I have used these before, and they work well. I just hate to pull out the existing unit if it still works. Thanks in advance for any help.

[crazy^millman]

Give this guy a try he seem to know alot about BTR untis and had alot of thing most did not.

 

William Timms Computers

 

 

He was a great help on a old Mori Pre DNC cerca 1979 I was helping a shop get running back in Jacksonville. I hope that helps.

 

Crazy Millman