Cylinder stock in wrong place (VERIFY X7)

[paulf]

I have seen a few posts on this subject - but no answers yet - I set stock correctly in machine group properties - stock setup - this is confirmed by stock display - so far so good - then goto verify - and stock isn't where it should be - go to verify settings and click stock setup - this should take values I put in at machine group stage and transfer them to verify - it doesn't??

After research I can see what it does - it uses the plane defined in machine group stock ok - but uses the offset ( view manager ) and adds it on- causing stock to be out in verify - does the same if I position cylinder manually in verify options - so unusable with cylinder -

To clarify - if you used Top as set up with no xyz offsets in view manager - this problem does not occur - if however you moved your wcs along 200mm in x and cylinder was in x axis - your stock would be 200mm out in verify - any solutions yet???? - thanks

[MrFish]

this is a bug in X7

[paulf]

A bug which has been fixed or being looked at ?

[Thee Rickster ™]

Create a solid and use that in verify

[paulf]

Yes can do that - but I don't usually - so needs a fix in x7- thanks