X7 verify won't work for lathe internal drilling,boring even center drill

[newbie70]

Hi Members

 

I upgraded from X6(32-bit) to X7 (32-bit)by using add-ons. I am unable to use verify for lathe - internal drilling, boring even center drilling. I get error as 'bad allocation'. Any fix for this problem?

Never had this problem with X6.

 

newbie70

[DODGERFAN]

Mine works fine, no issues at all.

[newbie70]

R J

 

Well I am getting this error only for drill operations. When I start with boring cycle, it works fine. I am using 4GB Ram and HP core i5 Intel machine with 1GB dedicated graphics.

Is it something to do with graphic card or ram memory?

Newbie70

[DODGERFAN]

Mine does just fine with drilling, I will say that since I installed X7 I have had some issues with drilling. Not with backplot or verify but with posting. I can set a drill to Z-1.5 deep and it will post Z.0 every time, so I have been doing hand edits after I post.

[newbie70]

R J

 

I don't have any issues with X6 back plot or verify which is in my other machine.

I will try with Z-1.5 deep drill to see where the core problem is? or is this happening only with your software.

 

Newbie

[DODGERFAN]

R J

 

I don't have any issues with X6 back plot or verify which is in my other machine.

I will try with Z-1.5 deep drill to see where the core problem is? or is this happening only with your software.

 

Newbie

I'm not sure if anybody else has had a problem with it. My issue is only the Z depth, too easy to fix by hand rather than have a post guru come in.

[newbie70]

R J

 

Too easy

newbie

[#Rekd™]

I had an issue with X7 verify last week and my reseller had me clear out my temp folder.

[newbie70]

H G

 

Would appreciate if u could tell me the location of temp folder. Thks.

 

newbie70

[newbie70]

^{I typed in %temp% and found number of temp folders including mastercam temp folders. I cleared some to no avail. Do I have to clear all of mastercam temp folders?}

^newbie70