machine simulation issue

[Chrisselfstarter]

Im trying to set up machine simulation and Im using a wcs that I created and is different from the standard  top view , so when I use the machine simulation my vise and part are oriented incorrectly, Im wondering if the machine simulation only references the top view or can I  somehow set the view in machine simulation to correspond to the view I have created for my vise and part so  that they are oriented correctly in the machine simulation ?

[Colin Gilchrist]

I believe there is a "Transform into WCS checkbox" that you can enable on the Machine Simulation Setup dialog.

[Chrisselfstarter]

Hi Colin I don't see the checkbox anywhere maybe you could walk me though to locate it

[Colin Gilchrist]

I'm not sure if this exists in other versions of Mastercam, but here is a picture from X7. This is the Simulation Startup Dialog box. The Checkbox is basically directly in the center of the dialog box, in the "misc" section.