have no "B" output on hmc while using axis sub

[nor750rr]

Hi guys this is a mc9 post but i was just wondering if anyone would know why i would have y moves but no B with it, i am trying to engrave a round dial on a 4th axis , i compare it with the program from a vmc and all the moves are right just no  output.

i know v9 is dead and gone but even just a nudge in the right direction would help.

[crazy^millman]

Sounds like you have it setup wrong. Front is B0 not top for certain pots so if you are going around the X axis you have a problem. If you are going around the Z axis and still seeing then not much anyone can do.

 

HTH

[nor750rr]

it is setup in front plane and around the y axis ?

[nor750rr]

sorrry around the x like you said .

[crazy^millman]

sorrry around the x like you said .

 

So it is setup like a Vertical and not a Horizontal. Can be done, but requires you to modify the output in the post to change it to what you are looking for. Good luck.

[nor750rr]

well  thanks anyway.