drill opr force out duplicate line help

[CVLVNB]

hi we  a  milltronics cent 1 and cent iv control

on the drill and tap it   position it diffrent than fanuc.

ex

N1137 G0 G90 G54 X-5.3548 Y3.0783 S1800 M03
N1138 G43 H6 Z1.
N1139 G98 G81 Z-.4 R.2 F15.625
N1140 X-5.1131 Y2.1856

G80

 

it should drill 2 holes; however; on the   milltronics cent 1 and cent iv

it rapid  to  X-5.3548 Y3.0783  (skip to the next hole )

X-5.1131 Y2.1856

 

and drill only 1 hole

it only works if i have dulpicated position

ex

N1137 G0 G90 G54 X-5.3548 Y3.0783 S1800 M03
N1138 G43 H6 Z1.
N1139 G98 X-5.3548 Y3.0783 G81 Z-.4 R.2 F15.625      ( duplicate  X-5.3548 Y3.0783)
N1140 X-5.1131 Y2.1856

G80

 

pdrill$          #Canned Drill Cycle
      pdrlcommonb
      pcan1, pbld, n$, *sgdrlref, *sgdrill, *pxout, *pyout, pfzout,     #  ( force out    *pxout, *pyout  ) and it not coming out
        prdrlout, dwell$, *feed, strcantext, e$

 

[Guest]

You cannot force out a post block

 

try using pfxout and pfyout instead.

[TheePres]

Depending on your post.might be a switch in "general output settings ".

Look for force_dpts

[CVLVNB]

thanks you.