MasterCam X10?

[PcRobotic]

Hello everyone, 

   I think I asked this question before and I just want to confirm if anyone know about this.  

 

   I'm trying to make the post reads from the top of the holder to the end of the tool as they both assembled together.  Somebody told me that they will make the data would be available in X10 because X9 does not exist for the data readout as 7.376.

 

  I'm hoping this is going to be happened because I'm using G10 for my horizontal.  This feature is GOLDEN for horizontal such as SHARING TOOLS and other minor purposes.

 

  The reason I'm asking is I'm now trying to prepare for my ACTIVE REPORT setup sheet to be reading out the value, so when X10 out the value will be available for my ACTIVE REPORT.

 

 

HOLDER image link:

https://drive.google.com/file/d/0B4UZsmondnEzbWFiWERaSVZRd2s/view?usp=sharing

 

Tools List Active Report:

https://drive.google.com/file/d/0B4UZsmondnEzV0pYYXF6RERrOEE/view?usp=sharing

 

 

Thank you for your responds. 

[Guest]

I never plan on anything being int he next version until it IS actually IN the next  version...too much history of things for various reasons falling off..

Oh and there is NO X10

 

Mastercam 2017

[PcRobotic]

Thanks JPARIS,

   I talked to my DEALER and he told me 2017 should arrive around APRIL to JUNE 2016.

 

 

Thanks. 

 

I never plan on anything being int he next version until it IS actually IN the next  version...too much history of things for various reasons falling off..

Oh and there is NO X10

 

Mastercam 2017