Globally reverse chains

[MIKO ELLO]

I was wondering if there was a way to take a program and globally reverse chains and move the tool start points 1 segment before a line.

 

I mirrored a part and I have mirrored parts several ways with the Transform but, I actually find it easier to just mirror my geometry and then reverse all my paths and start points. The problem is when I have a lot of these then I have to go back through each and every one of them.

 

Any tips would be appreciated if there is a way to automatically group and change all at once. 

[Gracjan aka Pullo]

Toolpath Transform , Source set to GEOMETRY (NOT nci otherwise Reverse order stays greyed out ) , Method Mirror and on the next page the magic happens when you tick Reverse order.  It's not exactly what you asked for , but sort of gets you there .

 

G

[MrFish]

It is possible to reverse a group of chains in each toolpath by using windows shift selection and right click reverse. This helps, but you still have to open each toolpath.