Mazak QT 10 with T1 controler

[Dan Bedore]

Is anyone out there using MasterCam to program A Mazak QT 10 with T1 controler it is an 80's machine a customer recently bought. does the standard post work for this machine?

[crazy^millman]

Dan I am no Mastercam Lathe guy. I did however run my share fo Mazak's. I would think that this si a Eia Machine fro mthe question you asked. They had Mazatrol on thsoe controllers but I beleive Eia was an opition. if it is Mazatrol you will need to get the Mazak thing that one of the other companies sell. If it is standard EIA then I would think the standard code will work fine. I think the only place you may run in to trouble is in the tool If I rmember right it is the T010101 for the tool call and the offsets.

 

Crazy Millman good luck and I hope this helps others to respond