ipm feed for tapping

[So not a Guru]

I have initialized use_rigid in my Generic Haas 3X Mill post, but the code is not outputting ipm feed, just the same G84 that simple tapping uses.

Can someone point me in the right direction to get the synchronous output?

[Guest]

Look down the list in the operations cut parameters, is there a rigid tapping option listed blow the tapping

Edited May 4, 2017 by Guest

[So not a Guru]

Yes,

[Guest]

So when you use that is it correct for what you're looking to do?

[So not a Guru]

3 minutes ago, JParis said:

So when you use that is it correct for what you're looking to do?

No, it does not. That is how I've been trying to get the code.

I did notice that the Generic Fanuc pmisc2$ postblock has a lot more logic in it that the Generic Haas does not.

[Guest]

Just now, So not a Guru said:

No, it does not. That is how I've been trying to get the code.

I did notice that the Generic Fanuc pmisc2$ postblock has a lot more logic in it that the Generic Haas does not.

Sounds like a copy and paste jobbie

Just make sure any variables there are also in the Haas post

[So not a Guru]

Yep, that's what I did after my last post. It works fine.