transform Transform Error message

[geirsj]

Hi!

First of all I like to kindly ask for some help, and bear with me as it is my first post here of a question so if this forum is the wrong place i apologize in advance.

 

Finally get my post processor up and running in 2018, and did the switch from X9.

I have some trouble with some files in 2017 and now 2018 when open files with transform operation

 

When i open some of the files created in X9 and earlier in 2018 I get this message:

If I choose yes it will regenerate the operations and let me post the G codes,

 

If I chose no it will give me this ERROR message

I choose geometry and not NCI as source, and just copy the source operations, not making new, and are using G54-G57

between points for a 4 vice setup.

 

this is the settings:

 

The Gcodes produced is not any different in X9 post or 2018 Post. the G codes is  correct

and I think I can still use the settings only with NCI as source.

 

 

Any suggestions on this?

[geirsj]

Now logged as R-13240