Remachining Pockets

[maestro]

When remachining a pocket with cutter comp in control checked, the code from my Fadal post comes out as if using wear comp. It does not matter if I check wear comp or in control, the code is the same. This is not good if everyone on the shop floor is using cutter comp in control. Is this something in my post or a bug. Using V8.1

[Allan Brown]

If present, you should delete this line in your post for V8.

158. Use wear compensation for pocket finish passes? n

 

[Trevor Bailey]

I am using a FADAL. I am not having the problem described above. My code changes correctly and I also have question 158 set to yes. Are you using a current post? Did you use the "uptxt" c-hook on the post in question?

------------------

Trevor Bailey

[email protected]

Specializing in Contract Programming

[maestro]

This line does not exsist in my post.

[Allan Brown]

Try using the Mpfan post out of the box in the same manner. Is the code the same for both types of comp? If Mpfan handles this correctly, you may have a post problem on your handles. If Mpfan repeats the problem, you should contact your reseller's tech support dept - possibly by email with the troublesome Mc8 file as an attachment.