Crash in wireframe

[Jeff2005]

I am using 2018 and i seem to be getting a lot of crashes when I am drawing simple radius' .  wireframe, fillet entities, i then enter an amount what i think the radius should be.  before accept i then may want to change the size of the radius, when i try and change it, then is when mastercam crashes.   Any one else experience this?

 

not sure about this explanation of this crash.  

thanks for any input or comments

[Guest]

With a drawing issue as stated....I think the obvious place to start is with the videocard.

Which videocard are you using and have you installed the latest driver?

 

[Jeff2005]

Nvidia Quadro M4000

[Jeff2005]

I inquired to CNCsoftware and they were able to determine that it was .NET issue.  They gave me a link to microsoft .NET framework 4.7 and i had our IT department install the needed file.  Seemingly, so far, all is good with no crashes.

 

thanks

JEFF