Line width issues

[sgargaly]

Hello

I have been using Mastercam version 2019 for a short time and I have noticed the line width for all geometry
is displayed at the narrowest setting. I can set the width to the widest setting and draw geometry but it is displayed
at the narrowest width.  When I analyze the geometry, the result shows at the widest setting. When I right click
on geometry and change the width to a larger setting, the geometry displays the same narrow width. Once again,
it analyzes as full width.  My on-screen fonts also stay at the narrow width and the result is small gaps in the characters both on screen and when printed. The printed output is difficult to see because of the narrow width of the font characters and geometry. I have not had these problems with previous versions of
Mastercam. I checked the status of the "Entity Attribute Manager" in settings and it is not active.
I also compared my settings with Mastercam 2018 and 2017 to the 2019 settings and
found them to be the same. The line width controls work fine in the other versions.
Is there a new setting or method in 2019 which locks out this adjustment or could a graphics card/computer issue be the cause in 2019?
Thanks.

 

 

[Guest]

I'm leaning towards graphic card setting...

I change my linie width all the time and it displays properly...I dug through the config, nothing jumped out as a setting..

 

[pullo]

Same here , works fine on my system , almost the cheapest Quadro I could find  (250E) , WIN10 - frozen in time  ver 1703 .

 

Gracjan

[sgargaly]

I am not certain because versions 2017 and 2018 work fine on the same computer and graphics card.