Is there any way to have the small image on the MILL 2 setup sheet show the projection amounts of all the assembly components of a tool? tool in the first picture was built in the stand-alone tool manager with assembly components in the assembly builder. When you look at the "holder" section of the toolpath parameters, it shows the projection amount for each component of the tool assembly. But when I output the setup sheet report (based off of MILL 2) I get the image in the second picture.

As I understand it, these registers can be setup to output modifications to cut condition codes (feed rate, on/off, MAO, etc) per each pass or even on specific lines of code using toolpath editor? How can I setup these registers and how do I call them in the post? Thanks

Found it, thank you. That worked.

Using MP Master with 5/30/19 last revision note. When I post a toolpath, or group of toolpaths that are all on B0. and do not have any other index positions, I do not get a B0. output. I have found some older forum posts recommending: #sav_rot_on_x = rot_on_x #Uncomment this line to output rotary axis value even when it's not used <--------uncomment this line but I cannot find anything like this line in the post?

I'm trying to use this, but am not sure where to put it, and where to put the call for it. Thanks

One simple work around is to move all your geometry far away from the system origin and use all user-created WCS/t/c planes. That way even though those system gnomons are still showing up in the screen shots but just can't be seen.

What's odd is that it is only showing up on certain views, and seems to only be happening with bookmarked viewsheets. If I do normal screen captures without the viewsheets function, then I don't get any of those Gnomons.

Here is an example setup sheet, with the Gnomons. I have all display settings for Gnomons off in MC that I know of. I cannot figure out where these are coming from. TEST 2.pdf

it shows up in both the setup sheet and the MC graphics window. Although, when I close/re-open the MC file, they will be gone from the graphics window. If you see my screen shot above, that is an example of what I am getting in the setup sheet. The Gnomon on the right is the T/C Plane, which I want. The one on the left is what is happening somehow in the image capture during setup sheet creation. The other strange thing is that they are not showing up on every image capture, but it seems to alternate every other capture. In this case I have the main graphics window capture and 3 view sheet captures. And what is weird is that when I post the setup sheet again, it seems to "switch" to the other set of captures?

I don't see anything when I do that search.

I am not sure abut Verisurf, could you send a screen shot of where I need to look for that?

I turned off Gnomon display completely and I'm still getting those random ones showing up.

When I use book marked viewsheets for image captures for setup sheets, I get these Gnomons that seem to be from the original world Top graphics gnomon. They appear along with the T/C Plane Gnomons on the image capture, which is not what I want. I want to only see the T/C Plane gnomon. Is there any way to turn this other gnomon off?

I see how the bookmarked viewsheets can help make the screen captures easier. Now the issue I am having is adding the CAPTURE sub-report to setup sheet design in Active Reports. I can't seem to get it to work as it does in the standard Setup Sheet (MILL).rpx

I'm am trying to add the -Setup Sheet (CAPTURE).rpx sub report to an existing Setup Sheet design, but cannot seem to get it to work. I looked at the Setup Sheet (MILL).rpx inside of Active reports designer as a guide. I thought I had put the sub report in the same place and all the same fields filled out, but when I go to post a setup sheet I just get a blank screen on the Active Report viewer. Thanks