If this was a year from now i would be interested in this one!

hey cncjb, where in PA are you located??

I would also would take a look if you like

It will not allow me to hit delete, right click does nothing and the file on the hard drive when you open it its just a bunch of weird stuff. I havent tried anything else yet

Can someone tell me how to delete operations from my libary? I have some that i never use and would like to be rid of them. Thanks

Thanks a lot

Hi all, Having some problems, its been a while since i have had to do a peck drill operation and when i backplot it does not show the pecks. Is this normal or am i missing something on my operation?

Ok now i have the tabs cutting off, but now i have a really long lead in line for no reason, it goes away from the part and then leads back in like 6 inches. Can any one help?

When i verify my program i notice that my cutoff operation for the tabs is not cutting the tabs off it looks like it is doing a finish pass on the top of the tab. What am i not doing right to have the tabs cut off compleatly?? any help would be wonderful.

I have a northwood router with a 210i-MB control, my question is why when i use wear compensation and place the radius in to the wear screen do i get an alarm? am i using the wrong comp type or am i inputing the wrong info?

Has anyone ever made there own pods of their router? I have a job where i have to use my aggrate head to cut some pockets for door pulls, was wondering if anyone had any good advice for me? thanks

Well i just cut some of the stuff and used a cheap carbide endmill, sounded like hell but finish was good.

Any one have experience cutting richlite? Wondering about feed rated to cut this stuff.

We use what is called prime preimum plus mdf, we also flycut our table, i usually do this 2 times per side when the sheet is new to remove any glaze and to make sure it is flat. we have a 40 horse pump, I also just purchased some rubber to place on the open parts of the table to be sure i am getting good vacum on the part.

I checked the T/C plane and all of the numbers are set to 0. Could this be some sort of problem with my post?