mpuvdd
-
Posts
4 -
Joined
-
Last visited
mpuvdd's Achievements
-
I'm curious to see what you find. I am still trying to make sense of it all. It seems that using Grime's first recommendation (add clearance and set feed plane to incremental) helped somewhat. Still, there are several bits of code missing a switch to G01. I tried the "force tool change" and did not notice any difference. I'll have a better update tonight on what's going on and may upload another file as well. Thanks thus far! You all have given me some hope!
-
Grimes, I am new and learning. I’ll give it a try tomorrow. Thank you! Seth
-
Thanks Leon. Clearance is off. Retract is off. Feed plane: 1.0 Absolute Top of Stock: 0.75 Absolute Depth: 0.005 Absolute
-
Running a basic contour ramp around the rectangular portion of a part results in one of two results when ran on our Fanuc Onsrud router: A. It ramps perfectly and cuts a rectangle with consistent 200 ipm feed rate B. It ramps with the first leg being a rapid move and the rest of the tool path being normal G01 F200. (See highlighted code) This happens on some parts but not all making me think the problem is driven by a geometry attribute. Any ideas? MCAM 2018 Ill upload a zip2go when I get a chance. Thanks, Seth
