Is anyone having any luck with Mastercam X2 MR1 on vista? I'm using an ATI FireGL 5200 graphic card with terrible results, any suggestions?? I'm ready to hang it up

I noticed the article on the what's new section. Not sure if it was released yet

Where can I find the X2MR1 update that supports Vista?

Does anyone know if there is a way to change the default from copy to move in the xform commands in mastercam x this can really cause a headache especially in solids since undo will not reverse this. Thanks

what files or folders to I need to copy from the first seat to the new seat of Mastercam X to keep all of the machine settings and default settings

Any suggestions on converting a 3D solid mold base to 2D geometry? Thanks

Thanks Dave and Paul Worked Great

We have a haas mill with a creative evolution controller. Running Mastercam X MR1 When I post any drill cycle the post is out of sequence. See Below N100 G81 X.2715 Y.3099 Z.1 P.1 Q-1. E.025 W.025 F4.5 N110 X-.9735 Y.3455 E.025 W.025 N120 X-.3236 Y-.3291 E.025 W.025 N130 G4 (PROGRAM NAME - MACHINE_GROUP_1 ) N140 G4 (DATE - 31-01-06 TIME - 08:29 ) N150 G4 ( NO. 7 DRILL TOOL - 1 DIA. OFF. - 0 LEN. - 0 DIA. - .201 ) N160 G4 T1 M6 N170 G40 T1 N180 G4 S1260 M3 N190 G0 X-.3236 Y-.3291 N200 G0 Z.1 N210 G4 M8 N220 G4 M5 N230 G4 M9 N240 G100 Z Y N250 M30 N100 110 and 120 are above the program name. Any Ideas

Same as Mark Bana The update manager could not locate the correct version of Mcam X.

Thanks so much jmparis Always = WCS did the trick.

Does anyone know of a way to lock the cplane to the top? sometimes when picking geometry for tool paths it will switcth to front.