We had the same thing when we went from 9 to x, in 9 had the post set so that when we put a neg spindle speed in we would get m04 ,they had to fix the post in x to get it to work Jason

Hi All, Was this a stupid question to start with or is this not possible? Jason mcx mr2 -solids

So is there a way to continue on the chain if you have to fix the geo. with out having to rechain the whole thing? Thanks Jason

We run at 150-300 rpm at 3 IPM

Just trying to use the last function in the options for chaining. What I'am doing for an example to try and figure this out I have two lines that cross near the ends,I chain one of the lines trying to get a single contour on both of the lines , but of course that won't work because the lines are crossing right , so now I trim the two lines go back to countour the path then hit last and the first line highlights then I countour the last line then I end up with two seperate countours.What am I not doing or doing wrong? Thanks Jason MCX MR2 - SOLIDS

Mark , When I do a closed chain (loop) in solids on a single machining of a dia. I can not dynamicaly or even change just the start point of the loop. Running mill level 2 mr2 Thanks Jason

When programing with solid ,when doing a contour chain is there any way to dynamicaly change the start or end of the chain as can be done with a standard contour chain , or is this to be added to the wish list? Thanks Jason

Thanks for all the reply's guys I changed the back ground color to 255 then it printed fine. I'am also on the maintance program and do have the latest up-dates and it still does not print correctly. Thansk again Jason

Can't seem to get print the geo. that I have on the screen. When I goto print preview it shows it all there , but when I print it only prints a couple of lines and the wcs . Thanks Jason

John, That worked Thanks once again Jason

Closed the mru , can't seem to find how to reopen it . Thanks Jason