kenfromlodi
-
Posts
261 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by kenfromlodi
-
When I post a G73 it comes out with bad numbers on the I and K lines. It's very odd, If it is on the OD both the I and K values will be zero. If the cycle is on the ID there will be a value on both I and K but they are wrong. The I value will be whatever the radius of the bore is and I am not sure where it calculates the K from but it starts farther away than it should also. I am using MCX2 mill level 3 and lathe level 1 Any help will be great. Thanks, Ken OVISO Mfg Concord CA
-
No I hadn't changed the u 2 to u 25. I just did it and it works now. Thanks for your help. Have a great weekend. Ken
-
There was no fs25 line, I added it. In my prvious reply does it look like I added it correctly? Thanks
-
John, I could not get it to change anything by adding this code. I tried just having the fs2 24 and just having the fs2 25 lines and I tried it with both. no change still a decimal. # Max depth to the right of the decimal point is set in the fs statement below fs2 24 0^7 0^7 #Decimal, 7 place, omit decimal if integer value fs2 25 0 3 0 3t #No decimal, absolute, 3 trailing
-
John, I found and changed the value from 2 to 4 but now it just posts out a "D0" for the depth.
-
I have four different lathe controls here and there is one sl-65 that will not run a decimal value in the depth of cut(D.075 will not work) it must be a whole number(D750). How can I have it post without a decimal? I am using X2 level 3 mill and level one lathe. Ken OVISO MFG Concord CA
-
Thanks John, It was the control definition setting. It is the "sequence number reset" that must be unchecked. Works great now.
-
Hi everyone! Great site this is all very informative, I am using X2( mill level 3 and lathe level 1) and I am having a problem with the canned cycles posting the same P(P100) and Q(Q110) line numbers for every tool. I have the post working pefectly except for this. Can anyone point me in the right direction? Thanks in advance. Ken OVISO MFG Concord, CA
