jorges
-
Posts
42 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by jorges
-
Hello, Can anybody share What's new X6 MU2 pdf. Just want to know the updates before I install X6 MU2. Thank you
-
Rickster, I did what you just said without results. When I try to open a file gives me a xxxx.mcx is not a valid win32v application Calvin, How do I check file association?
-
I can't open a Mcam file by double clicking on it since my X4 MU3 installation. I have to start Mcam and then open the file from there Any suggestions? Thank you
-
Hello all, Sometimes when I move or create a geometry using a solid model I end up with a 'net like' fake geometry that does not dissapear from the screen. After this I can't use printscreen shots to create my set up sheets because this interferes with my part picture. Any idea why or what cause this problem X4 MU1 Thanks
-
Thanks guys
-
I just switched to X4 and when I try to use depth cuts on my facing toolpath does not work when I hit apply but if I only hit OK works. Is this a X4 glitch or something wrong with my installation?? Any advice Thanks in advance
-
Hi all, I'm tapping copper buss bar alloy (1/2 thick), making 3/8-16, 10-24 and 6-32 holes and I have Electroless nickel coat, class 5 type 1, 1.0 mil thick min as a finish. QA says plate will build .002" around internal thread .004" overall. I need to use oversize taps, how big do i have ti go with drill and taps. Thanks
-
I will try that today Thanks guys
-
I programmed a prototype part a few months ago (X2 MR2) now is going on production. I have to make a few hundreds now and I'd like to run 3 vises (a part per vise). Is there a way to post my original program for 3 vises giving each vise a different work offset. I tried trasform-translate but could not figured it out the work offset part. Any help please Thanks
-
You were right crazym the problem was the misc real, it had #1 instead 0 Thanks a lot
-
Posting a program I'm getting M0s after tool change, between every cut and at the end of the operation. Somebody else created this program in some X version (do not know wich one). I'm using X2 MR2 for posting. Any help Thanks a lot
-
I would use .01" depth of cut to start with it(depending cutting tool) and .0005" chip load.
-
Thanks guys
-
Hello, I lost mi .MCX file but I have my .NCI file, can I post it and get my .NC file from it Thanks a lot for the help Jorge
-
Thanks
-
I am machining some M5 holes .5" deep with gold coated drill and cut tap without good results, drill just broke and tap cracked top of the hole, making also some M6 thru holes .875" deep. I was using 70 SFPM for drills and tapping 300 RPM. Any suggestions about speeds and feeds and any coated special taps that I can use for. Thanks