imm
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by imm
-
you need to work with your post their is a way to customize you post to adjust the feed rate for the periphery of the arc meaning when your cutter slows on the inside arcs and speeds up on the outside of the arc to keep the same chip load all the time. we tried to get our reseler to put it in our post but it was over their head. we showed MC this was a problem 10 years ago and it has not been address up to this point
-
Can we some how use a read buffer or a perread routine with a flag for the tool no. to the opp. no. to be recalled later
-
We are using the MPMASTER post with a lot of changes in it. For HAAS' and GE 1050 controls
-
The veriable next_tool gives you the next tool used but with that in mind if in the next opp. I am using the same tool how do I find that tool in the post. We are using the MPMASTER post with a lot of changes in it.
-
Does anyone know the variable's name holding the next operations tool number. This is not the variable next_tool I would like to know whare i can find the next operations tool number befor leaving the presant operation. thanks Richard