hole axis and auto hole axis is what I use. I have seen a lot of replies for pierce point. What does that do?

Anyone else have an issue with your step down automaticaly changing to 10% of cutter diameter when you change cutter diameter in the HST tool paths

Im a little behind just started using 2020. Has anyone else noticed ehen you change your cutter diameter in I believe any HST toolpath for sure in waterline. It will automaticaly change your stepdown yo 10% of your cutter diam. This is extremely annoying is there a parameter im missing that will fix this?

I have a prblem I run in to alot when drilling deep holes. If I have say a 7 inch deep hole to drill I like to start out with a regular jobber length drill which will dill about 3to 4 inches. Then when I come back with a longer drill I cant figure out a way for the drill to start at the bottom of the first hole but retract all of the way out of the hole when it pecks. if you put your star ht at -3 inches that is where it retracts to when it pecks. So basicly I would like the drill to start at say -3 and retract all of the way out of the hole when it pecks. I called local mastercam dist they said there is no way to do this in mastercam. I find this hard to believe. Anyone know a way to do this