CRW
-
Posts
34 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by CRW
-
How about turning the part and performing the secondary operation with Wire EDM?
-
Thank You, Thank You!!! That was it!! I needed to "toggle" shading.
-
I'm trying to coordinate with my reseller to attend a class. Not many resellers seem to have a class for solids. I travel a bit, so that's a challenge as well. Online training would be "plan B" for me. I always do better with direct instruction... or at least I have in the past.
-
I just tried drawing exercise #2 in the tutorial, but the end result somehow comes out as a wireframe and not a solid... But that's a whole different post. Thanks for all of your inputs. Cliff
-
Thanks to all of you for your constructive posts. I've gone ahead and purchased the MC Solids add on. I will at some time in the not to distant future most likely purchase a seat of SolidWorks too. I just tried drawing excercise
-
Thanks for the input. I didn't mean to be so cryptic or vague. I will be using to mostly design brackets and assemblies. I'd be doing these on and around engine assemblies, so I'm not sure if importing that kind of geometry to too much to ask out of MC Solids. I'll be the one doing all the drawing, so having enough time to learn a different software package is also a consideration.
-
I'm wondering how many of you are using MC Solids. NOT MasterCam for Solidworks. We're a small company, so it's more cost effective at this point to add on Solids rather than purchase a seat of SolidWorks. My only issue is that there doesn't seem to be any training through my reseller, or any others in the surrounding areas. I'd appreciate any suggestions.
-
Small hole EDM?