Thank you all VERY much for all the help. The 2D toolpath-pocket and Toolpaths surface Rough with enable cavity do not seem to be compatible when pocket standard is selected in source operations. Maybe the HLE version has a problem with this I get multiple errors .

TUTORIAL #7 WIREFRAME MILL LEVEL 3 F.zipTx 4 response I get failed to get motion to project please regen operation error reading from surface machining temp file

Hi everyone I am looking to find how to machine the M into the part. This is the last lesson for mill level 3 so I am looking forward to wrapping it up. Thanks to everyone who has posted for me.

Hello I created the geometry a little different than the tutorial and then it worked thanks for the help

TUTORIAL #7 WIREFRAME MILL LEVEL 3 C.zip I did one of them by accident I redid the create curve on one edge and retried and it worked sync chains is new to me right now I wish the tutorial book explained this more they must know this problem

Hi. actually I do not, I tried all the sync options in ruled lofted but no luck I added a screen shot I have only been learning Mastercam for 2 months I still need to learn more

Hello all thanks for all the help with all of my questions I've had. I can't seem to get the ruled lofted to work properly on these chains. I was wondering if someone could tell me what is wrong I try to start them in the same spot and chain them in the same direction but no luck. Thanks all.

I must say a lot of Tutorial # 6 is messed up, it is like nobody poof read it at all

Hello all

Hello all. I am having a problem with this fillet. This is mill level 3 Tutorial # 5. In the book there is a note NOTE: The fillet surfaces are generated correctly but the draft surface is not trimmed. To fix this you should enable EXTEND SURFACES in the FILLET-SURFACES OPTIONS as shown. This does not fix the problem does anyone have a fix for this.

thank you all I did get it I had to reclick on second surfaces again to reaim the arrows or it would say no fillets selected thanks again everybody

here is a zipped file mill level 3 tutorial # 1 Review Exercise C.zip

Yes the trim box is checked

I have tried this many times it doesn't work but thanks for your help

I added pic of how fillet turns out